After the introduction of my last two articles, I believe you already know how to install different types of solar cat eyes road studs, but some friends said that they will encounter various problems during the installation process, regarding the usage scenarios of the solar road studs and the tips needing attention in the installation, I have summarized some for you, and hope to have some help for your problems.
1. Dangerous blind corners and sharp-curves, black spots and poorly lit areas.
2. Areas with unpredictable weather conditions
(coastal roads, foggy areas, wet and rainy regions, etc.).
3.Joint intersections, on and off ramps, center lines and dividers,
4. entrance warnings, carpool lanes, bridges, cross and side walks
4. Guidance lines, traffic islands, roundabouts and mountain roads.
5. Taxiways at airports, bike and pedestrian lanes, aboard ships and watercrafts.
6. Entertainment areas, parking lots, hotel entrances and gas stations etc.
• Check if the solar road stud charges and discharges normally
• Identify the place for installation
• Clean road surfaces
•Every time glue mixing shall not exceed 3kg (because glue mixing will be solidification after a certain time, so, to avoid waste, please don’t mixing glue more than 3kg each time).
•When the working temperature is below 10 degree, glue not easily be mixed, then should use kerosene stoves to heat glue (heat A glue only, B glue can not be heated). Use mixer to make them mixed uniformity.
• Clean the bottom of the solar cat eyes and use epoxy glue to stick it to the ground
• Wait 8 hours for drying before activating solar cat eyes road stud.
• Caution: never installed in the central line (Unless the solar cat eyes road stud is dedicated to the road center line)
•Make sure no vehicles press on the solar road stud .
If you need more help about inatalling solar cat eyes road stud, welcome to contact us at info@rctraffic.com!
